Construction site enclosure spraying is a common safety protection measure. By using a spraying system, the diffusion of pollutants and noise on construction sites can be reduced, dust can be reduced, the construction environment can be improved, and the health and environmental quality of surrounding residents can be protected. The spray system can be programmed according to a fixed time and spray volume, with a high degree of automation and easy operation.

在建筑工地圍擋噴淋的工程實施中，需要注意以下幾點：

In the implementation of construction site enclosure spray engineering, the following points need to be noted:

，應根據工地實際情況進行勘測，確定噴淋管線和噴淋頭安裝位置，并考慮噴淋管的安裝高度、噴頭噴射方向角度和噴灑范圍，一般3-4米安裝一個噴霧頭，安裝時需車緊噴頭，高壓管安裝到位。

First of all, survey should be carried out according to the actual situation of the site to determine the installation position of the spray pipeline and the spray head, and consider the installation height of the spray pipe, the spray direction angle of the spray head and the spray range. Generally, a spray head is installed at 3-4 meters. During installation, the spray head needs to be tightened and the high-pressure pipe is installed in place.

其次，應選用合適的噴淋設備和高壓管道材料，保證設備穩定可靠，并注意采用防止凍裂的措施。

Secondly, appropriate spraying equipment and high-pressure pipeline materials should be selected to ensure the stability and reliability of the equipment, and measures to prevent frost cracking should be taken.

再次，噴淋水源應確保供應充足，并考慮配備水泵設備或蓄水池等外部水源保證正常使用。

Once again, the sprinkler water source should ensure sufficient supply and consider equipping external water sources such as water pump equipment or reservoirs to ensure normal use.

應加強日常維護和管理，安排人員定時更換噴淋泵機油，避免缺失機油導致拉缸；注意清洗噴嘴、檢查管線和閥門等設備運行情況，及時處理?yè)p壞和故障，保證系統正常運行。

Daily maintenance and management should be strengthened, and personnel should be arranged to regularly replace the spray pump oil to avoid missing oil causing cylinder pulling; Pay attention to cleaning nozzles, checking the operation of pipelines and valves, and promptly handle damage and faults to ensure the normal operation of the system.